The pedals are fabricated from 1/8" flat stock. We haven't hit anything yet, but we suspect that it will bend the angle into the tire and cause a lot of grief. The front bumper sized as shown will clear only for 4" wheels. You could instead have one support coming in from the side at an angle. The steering arm is very sturdy in this set up. Careful though that your mounting bolts will still fit. That is for support for the mounting plate. Notice the boxed in area at the rear left axle. Step 2: Using a tube bender with a X 4 bending die, make the bends in the tube to create part number WP-908-2 as shown on the drawing. When building the frame, don't weld up the engine mounting plate until you fit the engine. 24 Steps To Building A Killer Go Kart Frame Step 1: Referring to the cut list on page one of the drawing, cut a length of X. To attach it to this frame we'll probably use cotter pins. This design will incorporate the adjustable seat. We elected to make a two seat go kart, and made it long enough that a six foot tall person could fit in it. Here we lay out the frame on level concrete which, if you don't have a giant welding table, is quite handy.Įnsure that you use a square to make sure you're getting the angles right. Since everything else builds from this, you don't want to start the project with a frame that isn't true. Two Seater Frame How to Build a Go Kart Frameīuilding a frame is not complicated, but you must ensure that you're building it square.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |